Summit-audio MPC-100A Mic Preamp Compressor Manual de usuario

Summit Audio Model MPC-100AMic Preamp/ CompressorOperating ManualIMPORTANT!: CAREFULLY READ THE ENTIRE INSTRUCTION MANUALBEFORE HOOKUP OR OPERATION OF

Electrical Connections:(This MPC-100A is wired as a pin 2 hot device. Units made before March 1st, 2003 comefactory wired with pin 3 hot.)Input:Unbala

Note on specifications: Summit Audio is uncompromisingly committed to excellence. Allof our specifications are made with the latest technology and ar

Product IntroductionThe Summit Audio MPC-100A Mic Preamp/ Compressor-Limiter is a singlechannel tube preamp and tube compressor/limiter all in a two-s

THE CONTROLS1. Line/Mic/48 3 position switch selects the input being used, line or mic, and alsoengages the phantom power +48 volts for condensor mic

Output Section Controls:14. Output variable resistor controls overall output signal level; this is a post-preamp and post-compressor gain control

1. 5. 7.2.9.3. 4.12.6.13.8.15.10. 11. 14.16.

Use Scenarios and set upRecording and compressing a stereo mix: Insert a ¼” patch cord into thestereo link jack on the back of two MPC-100A’s (or a TL

De-essing: (Requires external EQ) Plug a TRS insert cable into the sidechain jack on the back of the MPC-100A. Plug the send (tip) of the insertcable

Further Notes……Linking: use a 1/4" mono patch cord with tip~signal and sleeve~ground; the MPC-100A which is set for more compression will act a

A Word About Tubes The tubes that are used in the MPC-100A are selected to give the best possibleperformance in the position that they are in the cir